Parts of the Cartridge Case
2 posters
Page 1 of 1
Parts of the Cartridge Case
Parts of the cartridge:
There are 5 types of Cartridges:
Rimmed
Semi-Rimmed
Rimless
Belted
Rebated
Rimmed Case : A rimmed case is distinguished by a rim that extends outward from the head of the case, to a diameter noticeably larger than the case body. (44 magnum, 303 British, 38 special, 357 magnum, ect.)
Semi-Rimmed : Semi-rimmed design is a rim only slightly larger than the case body itself. (.25 ACP, .38 Super)
Rimless : Despite the “rimless” designation, the case does indeed have a rim to facilitate extraction. In this design, however, the rim does not extend beyond the case body. Rather, the rim diameter is approximately equal to the diameter of the case body itself just ahead of the extractor groove. (.30-06, .270, .308 ect)
Belted : The defining characteristic of these cartridges is a small band, or belt, around the head of the case, just ahead of the extractor groove. In use, the belt acts in exactly the same manner as a rim. Originally, this was an absolute necessity, owing to the steeply sloping shoulders of many of the first belted cases. (.7mm Remington Magnum, .300 Winchester, .375 H&H Magnum)
Rebated : the rebated case is characterized by a rim that is noticeably smaller in diameter than the case body. The intent of this design is normally to offer increased case capacity without altering or enlarging an existing bolt face. (.41 AE, 50 Beowulf)
Information gathered and used from
http://www.exteriorballistics.com/reloadbasics/cartcase.cfm
Last edited by Daywalker on Thu Jan 06, 2011 1:50 am; edited 1 time in total
Daywalker- Admin
- Posts : 2324
Join date : 2010-10-18
Location : Virginia
Re: Parts of the Cartridge Case
I looked at the link you pointed to and maybe it would be better to call this "Parts of a cartridge case" instead of "Parts of a cartridge". A cartridge has a bullet and a primer and powder.
EdgarEg- Member
- Posts : 579
Join date : 2010-12-17
Re: Parts of the Cartridge Case
Point taken!! I will change the title....
Thanks....
Thanks....
Daywalker- Admin
- Posts : 2324
Join date : 2010-10-18
Location : Virginia
Similar topics
» Is .45 ACP the name of the cartridge or the name of the gun?
» gunsmithing parts and supplies
» pains of ordering parts
» Stuck Case Renoval
» Ar15 parts swapping thoughts
» gunsmithing parts and supplies
» pains of ordering parts
» Stuck Case Renoval
» Ar15 parts swapping thoughts
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum