Brass conversion 32 win from 30-30 win?

Hello, how do I make the brass from a 30-30 win into a 32 win case?

I have never done this conversion so I am assuming that the 30-30 and the 32 are basically the same case. If the rim is the same and there is no appreciable difference in length other than the diameter of the bullet just lube it up and run it in a 32 full length resizing die then trim the case to length and fire form the case. If the 30-30 is not the parent case for the 32 then you are barking up the wrong tree.

If you have a 32 trim die back off the die till it just contacts the case then lower the ram a little and screw the die down a 1/4 or 1/2 turn and repeat till your at the trim length. Trim then run in the full length die and retrim . I have done this with 30-06 cases to make .243 and .308 you may need to out side neck turn if the are to thick.

Right from "The Handloaders manual of cartridge conversions" 4th edition.

Make from 30-30 win. Anneal neck and F/L size. Square case mouth. Chamfer.

Load data listed is
170/FN 31.5 gr.IMR 3031 2100 fps.

The Speer manual I have handy shows 32 to 34 gr. Of IMR3031

Incidentally I have converted 32WS brass to 30-30 but never 30-30 to 32WS.

I also suspect that you could make 32WS from 9.3X72R since it is listed as a use for making 30-30 brass. ie: 9.3X72R will also form in the same manner but require a bit more swaying.

Thanks for info!